S&S Enterprises, Inc

Directions For Use

Directions For Use

As a rule of thumb, products that do not harden, i.e., most caulks, contact adhesives, labels, decals, tape residue, gum, sap, tar, can be removed with Re-Mov Adhesive & Silicone Remover. Hardened products such as Super Glue, two part epoxies, urethane floor coatings and varnishes cannot be removed with Re-Mov Adhesive & Silicone Remover



For silicone, polyurethane, and polysulfide caulks, first cut away any excess caulking then work Re-Mov Adhesive & Silicone Remover from the edge(s) of the bond with a scraper or a putty knife. Re-Mov Adhesive & Silicone Remover will work its way under the caulk and release the bond. If residue remains, simply re-spray the area and wipe it clean with a terry type cloth. If you spray an area by mistake, either wipe it dry or let the Re-Mov Adhesive & Silicone Remover evaporate, the caulking will not be affected.


Contact Cement/Glue

Coat the area with Re-Mov Adhesive & Silicone Remover and let it sit. The longer it remains on the adhesive the easier your job becomes. Then wipe the area with a clean cloth. If any residue remains, repeat the first step. When using Re-Mov Adhesive & Silicone Remover to remove carpet or headliners, spray the surface heavily, wait at least 15 minutes and test a portion of the item to be removed. If the item remains secure, re-apply Re-Mov Adhesive & Silicone Remover and wait an additional 15 minutes before removing the item.


Polyurethane Expanding Foams

Spray the contaminated area with the Re-Mov Adhesive & Silicone Remover and wipe the area with a clean cloth, note once the foam has cured the Re-Mov Adhesive & Silicone Remover will not remove the residue.


Tape/Labels/Stickers/Decals/Pin Striping

First, spray the item to be removed and let sit for a minute. You will notice that Re-Mov Adhesive & Silicone Remover penetrates from the edges inward. Use a sharp object to work the edges and re-apply Re-Mov Adhesive & Silicone Remover. Once there is enough material to grab, slowly begin pulling the item away from the adhesive while spraying Re-Mov Adhesive & Silicone Remover on the back of the item. It should pull away with ease.



To remove gum from carpets, clothing or fabric, just spray with Re-Mov Adhesive & Silicone Remover, wait a minute, and rub the area with your fingers or a stiff nylon brush.



All of the above will readily dissolve in Re-Mov Adhesive & Silicone Remover, just spray, wait, and wipe.

Re-Mov Contact us

get in touch

Have a question? Give us a call or fill out the contact form – we'd love to hear from you

Office: 2402 Primrose Lane, Aberdeen, SD
Phone: 605-290-2055
Email: removadhesive@gmail.com